Normally, the light will appear purpleor violet, and the skin will not fluoresce. However, certain bacteria, fungi, or changes inpigmentation of patient skin will cause the affected area of the skin to change color under light; hencethisis used for inspection and detection of certain fungal infections. Wood's light is not atherapeutic or treatment device. [2] When the bolts were installed, I attached the first chain and marked the length I wanted it to be. I then marked this length on all four chains and cut them to length using an angle grinder. With this done I attached all chains to the bolts.

Once one side was cut to the 6″, the other side could be cut on the table saw. This second cut is the 2″x6″ board for the ceiling support. We cut this board to 27″.Complement the lighting in your dining room using good orientation lighting, such as wall lights. These provide a soft, shadow-free light and can be switched on in addition to your pendant light to avoid strong light-dark contrasts in large dining rooms, which helps to reduce eye strain. Wooden pendant lights can be that extra something for your home – for every style of furnishing. That’s because: Take one of the screws and push it through each of the pre-drilled holes. Make sure you apply pressure so that it indents into the drywall. Now you need to determine where the trusses (studs) are in the ceiling and which way they are running. You have to attach the ceiling support to at least two trusses in four places to hold the weight of the beam. SIDE NOTE: Our center point was centered between two trusses, so adjust these steps to fit your space.

Pendant lights work well in almost any interior style – after all, you always need light for you dining table! Remember, in step one you determined the location of where the center of your beam will be plus the center of the trusses. You are now going to prep the 2″x6″ wood ceiling support to attach to these marked locations.Hopefully, these trusses are centered to your beam center. If not, you can make your wood ceiling support longer to adjust to this or move your center spot. Ours was centered so our wood ceiling support board was cut to 27″. Since the entire construction ended up weighing close to 50kg I didn't feel comfortable using normal wall/ceiling anchors. Therefor I chose to use wedge bolts. These bolts, when mounted in concrete, are rated for around 750kg (x4 = 3 tonnes, which I know seems like overkill, but better safe than sorry). TIP: It would have been easier to use an Oscillating Dremel but we could not find my dad’s tool anywhere, so we improvised.